HOW TO PRODUCE PAINT (EMULSION)

HOW TO PRODUCE PAINT (EMULSION)

INGREDIENTS

(1) WATER
(2) TITHERNI (USE ONLY FOR THE PRODUCTION OF WHITE PAINT)
(3) CACIUM CARBONATE (CALCIUM CARBONATE (CALCIUM)
(4) COLOURITE
(5) P.V.A
(6) FORMALLIN
(7) NITROSOL
(8) AMMONIA
(9) HYDROSOL
(10) ACRYTEXT

STEP 1 MIX CALCIUM CARBONATE IN WATER DEPENDING ON THE QUANTITY OF PAINT YOU WANT TO PRODUCE NOTE THAT IF YOU ARE PRODUCING WHITE PAINT YOU WILL MIX TITHERNI IN WATER BEFORE ADDING CALCIUM ADD SOME SPOONS OF TITHERNI AND MIX VERY WELL WITH CALCIUM AND WATER.
STEP 2 ADD YOUR PREFFERED COLOUR, IT IS ASSUMED THAT BY NOW YOU MUST HAVE DILUTED THE COLOURS AS REQUIRED WITH WATER IF THEY ARE OXIDES, NOW PUT COLOUR IN SMALL RATION AND MIX PROPERLY UNTIL YOU GET YOUR DESIRED RESULT. YOU CAN ALWAYS ADD MORE IF YOU LIKE. SUPPOSE YOU ADDED MORE YELOW FOR EXAMPLE THAN YOU NEED YOU CAN ADD CALCIUM (BUT NOT AFTER THIS STAGE) BEAR IN MIND THAT THE COLOUR MAY BE DEEPER WHEN WET AND LIGHTER WHEN THE PAINT IS DRIED.
STEP 3 ADD P.V.A TO THE MIXTURE AND AFTER TURNING ADD HALF GLASS CUP OF NITROSOL. NITROSOL IS ALWAYS IN POWDERY FORM SO YOU MUST DILUTE IT IN SMALL WATER BEFORE YOU ADD TO THE MIXTURE THEN ADD FORMALIN AND AMMONIA AND HYDROSOL SEQUENTIALLY IN THE SAME QUANTITY AND THEN TURN VERY WELL AT ANY ADDITION OF A NEW C HEMICAL. AFTER YOU HAVE COMPLETED THE ABOVE MAKE SURE THAT YOU TURN THE ABOVE MIXTURE VERY WELL, THEN ADD ACRYTEXT TO THE MIXTURE AND TURN AND ADD IT IN SMALL QUANTITY UNTIL YOU GET THE THICKNESS YOU DESIRE HOWEVER IF YOU ADD EXCESS YOU MIGHT SPOIL YOUR PAINT.

NOTE YOU SHOULD FOLLOW THIS IN THE MANNER I STATED THEM IN THIS WRITING IN OTHER NOT TO SPOIL THE PRODUCTION AND NOW YOUR PAINT IS READY FOR USE.